Audioengine HD3 Speakers

In this video we take a look at some small speakers that put out big sound from Audioengine, the HD3. To take a closer look or to make a purchase make sure to check them out at Features: - General: Type: 2.0 powered multimedia speaker system Amplifier type: Dual analog class A/B monolithic Power output: 60W peak power total: 15W RMS / 30W peak per channel, AES Drivers: 2.75in Kevlar woofers, 3/4in silk dome tweeters Inputs: 3.5mm stereo mini-jack, stereo RCA, USB, Bluetooth Outputs: RCA variable line-out, 3.5mm mini-jack headphone out Mains voltages: 110-240V 50/60Hz auto-switching SNR: 95dB (typical A-weighted) THD+N: less than 0.05% at all power settings Crosstalk: less than 50dB Frequency response: 65Hz-22kHz ±2.0dB Freq. response w/bass reduction switch selected: 100Hz-22kHz ±2.0dB, -5dB down Input impedance: 5K ohms unbalanced - Headphone Amp: Headphone amp type: OPA2134 Full-scale headphone output level: 2.0V RMS Output impedance: 2 ohms Recommended headphone impedance range: 10 ohms to 10K ohms - Bluetooth: Internal D/A converter: PCM 5102 Input bit depth: 24-bits, upsampled Bluetooth receiver type: Bluetooth 4.0 audio Supported codecs: aptX, AAC, SBC Wireless operation range: Up to 100ft (30m) typical Input data rate: Determined by Bluetooth Wireless latency: ~30 milliseconds (ms) - USB: Connector type: Micro-USB USB device class: USB 1.1 or above Internal D/A converter: PCM 5102 Input bit depth: 24-bits, upsampled Input data rate: 44.1KHz/48KHz Protection: Output current limiting, thermal over-temperature, power on/off transient protection -Materials and construction: 18mm thick MDF cabinets with real wood veneer 3/4in silk dome tweeters with neodymium magnets 2.75in Kevlar woofers with advanced voice coils